SF Robotics
Discuss a project

Electrical & electronics

Automate component handling, kitting, cable and harness routing and assembly support for electrical and electronic equipment.

What we develop

We build robotic stations for electrical and electronic equipment assembly and component handling, including work around panels, enclosures and equipment frames.

  • Job kittingStage connectors, fittings, fasteners and harnesses against the work order.
  • Cable and harness routingRoute and dress cables and harnesses along a defined path, through clips and guides, to their connectors and terminal points.
  • Component placementOrient housings, support cable assemblies and position parts at an enclosure fixture for fastening or wiring.
  • Verification and traceabilityCheck part IDs and kit completeness before handoff to the assembly or test team.
Open electrical enclosure with routed cables, breakers and terminal blocks
Electrical control enclosure

Example electrical enclosure job

  1. Match connectors, harnesses and hardware to the work order.
  2. Present components at the enclosure fixture in the required orientation.
  3. Route cables and harnesses along the planned path and seat them at their connectors.
  4. Record the kit, placement and routing checks before passing the job to assembly or test.
Scan the work order, kit the connectors and harness, present the kit at the enclosure fixture, then check the part ID and orientation.

Work orders and traceable parts

Use the customer’s parts list, revision and serial or lot requirements to verify the job kit.

Connector and harness handling

Use real samples to check connector orientation, protected surfaces and how harnesses can bend during placement.

Cable and harness routing

Define the routing path, clip and tie points, bend limits and connector mating checks with your engineering team, using real harnesses and the routing drawing.

Release to assembly or test

Agree which presence, orientation and ID checks release the job to the team responsible for electrical assembly and testing.

Electrical equipment and installation

We can tailor part presentation and inspection records to your product specifications, including IEC 61439-2 when it applies to low-voltage switchgear assemblies. For U.S. installations, we coordinate equipment interfaces with your electrical team around the edition of NFPA 70 (NEC) adopted at the site.

Discuss an automation project

Contact SF Robotics